N SPORT Seat rail Products
Universal Mounting Stay
Features
N SPORT General-purpose Side Stays for Seat Rail
General-purpose side stays that accommodate many seats and offer fine height adjustment and lateral adjustment.
These side stays are common to seat rail models S1, S4, S6, S16, S36 and LS9 and to model S1 for Porsche.
Detail
The bolt holes used for mounting the seat itself are cut into elongated and diagonal shapes. In addition, the bolt holes for attaching to the sliders are elongated, which allows for mounting of many seat models. In addition to offering fine adjustment of seat height and seat angle, these side stays provide lateral seat adjustment to the left and right. They are also compatible with seats with a high bolt-hole mounting position,* such as the Recaro RS-G. In addition, weight-relief holes are provided for maximum weight reduction.
* Depending on the seat rail used and whether the seat bottom is above the face of the sliders, seats with higher mounting positions at the rear can be used only with the bolt holes at the top of the side stays.
Specification
Black, baked finish
Mounted size:
A: 290 mm (±5) from front to rear of side stay × 355–450 mm left to right*1
B: 260 mm (±5) from front to rear of side stay × 355–450 mm left to right*1
C: 233 mm (±5) from front to rear of side stay × 355–450 mm left to right*1
D: 12 mm
E: 297 mmKit contents:
Side stay × 2 pcs
M8 × 25-mm cap bolt × 4 pcs
M8 × 20-mm hexagon bolt × 4 pcs
M8 × 30-mm hexagon bolt × 4 pcs
M8 flat washer × 8 pcs
M8 flange nut × 4 pcs
6-mm spacer × 4 pcs*2
3.2-mm spacer × 8 pcs*3
*1 The measurement of 355–450 mm applies when mounted on a seat rail with a mounted size of 405 mm left to right.
*2 For models requiring relocation of the seat belt buckle.
*3 For use between the seat and side stays when the seat width is narrow or when an offset to the left or right is desired.
Tips for mounting the seat to the side stays
Mount the seat to the side stays as orientated in the illustrations below. The installation width of the seat to be installed determines the orientation.
Adjustments required to center the seat relative to the steering wheel (adjusting the seat to the left or right) are performed by changing the orientation of the side stays as they mount to the seat rails.
Use spacers if the grommets of the belt holes interfere with the side stays, creating a gap between the seat body and the side stays.
(Adjust the number of spacers to fill the gap.)
Even if no interference occurs, a gap may be present depending on the width of the seat to be mounted. In that case, use spacers as well. (Use 30-mm bolts when using spacers; use 20-mm bolts when not using spacers.)
Note: Various spacers and bolts are included with the seat rail.
Conform
Compatible Auto Makers and Compatible Seats
 |  |  |  |  |  |
 |  | ||||
| We suggest confirming the mounted size before purchase. | |||||
